Solener Inverter 4000W / 48V

They use PWM modulation with full bridge. They comply with the applicable standards about harmonic content and EMI-RFI compatibility. They are protected against short circuit, overload, overheating, overvoltage, transitories and polarity inversion. Polarity inversion does not destroy any fuses as in inverters from other manufacturers.

Some versions have an input control which allows the inverter to be remotely switched on and off. Other versions have buttons, allowing the configuration of the device depending on the user requirements. All inverters but the S250 have a LCD display, which can display information in Spanish, English, French, German and Portuguese as configured in the main menu.

In some versions the inverter reconnects automatically when the conditions that caused the fault disappear (low or high battery, overheating, external control). It does not reconnect automatically in case of overload or short circuit (optionally, it can restart after a few minutes).

The tracking threshold can be adjusted using a potentiometer located in the front from 0 W (always connected) to 60 W. If the connected load power is lower than that adjusted with the potentiometer the light will blink with a frequency of 1 Hz. This adjustment is necessary because the applications are very wide and the installation cabling may also cause power drops (by capacity and by radiation).

Customer Reviews: